How To Use; Switch On: (Parent Unit + Baby Unit); Volume; Sound Lights - Alecto DBX-10 Mode D'emploi

8.

HOW TO USE

Switch on: (parent unit + baby unit)

Hold down the
light comes on after about 3 seconds.
When the power adapter is connected to the
parent unit the power light will light continuously.
When the baby unit is powered with batteries the
power light will flash.
Press the

Volume:

Pressing the
the volume of the sound coming from the speaker. You have a choi-
ce of five volume levels and volume off. Two beep tones will sound
when the maximum volume has been reached.

Link check:

A red link light will flash and a beep tone will sound continuously if
the connection between the parent unit and the baby unit has been
broken. This can happen if the parent unit is out of range from the
baby unit or because the power on the baby monitor has run down.
Once the connection is restored again, the
light will go out and the beep tones will stop.
Bm1117
button until the power
again for 3 seconds to turn off the unit.
and buttons on the parent unit allows you to set

Sound Lights:

The parent unit comes with five audio lights. The
louder the sound that the baby unit picks up, the more the lights
will show up on the parent unit. In this way, you will know when
the baby is crying, even when the sound of the parent unit is
switched off.
Bm1117
Bm1117
Bm1117
-19-
Power-
light
Button
LED for
link-check
GB