Connecting To The Power Supply - Carat P-3500 Série Mode D'emploi

6. Moving wheels Kit
One person, using the "MOVING WHEELS"
accessory, can move the machine.
WARNING !
IN ORDER NOT TO COMPROMISE THE STABILITY
OF THE MACHINE, FOLLOW THE INSTRUCTIONS
BELOW CAREFULLY.
SUPPORT THE MACHINE WHILE INSTALLING THE
WHEEL KIT.
With the machine in a working position:
a) move the beam to the 30° position;
b) loosen the leg-lock on the opposite side to that
of the control unit;
c) lift the leg and insert it into the wheel support
(photo 8);
d) lock the leg in position using the leg lock;
8 8
e) tighten the wheel support screws (photo 8);
f) repeat this operation on the other leg.
INFORMATION
TO FACILITATE MOVING THE P-3500 ON SITE,
IT IS ADVISABLE TO PUT IT IN THE LOWERED
POSITION.
a) Slacken the leg locks on the front one at a time,
supporting the machine by the carrying handles;
b) lower the front of the machine by allowing the
legs to slide into the supports until the middle
hole on each leg is aligned with the hole in the
supports (photo 9);
c) lock the legs in position using the relevant
clamps;
d) repeat the operations indicated under a), b),
and c) for the rear side.
9 9
MOVE THE MACHINE AS SHOWN IN PHOTO 10.
1 1 0 0

7. Connecting to the power supply

WARNING !
This machine must be connected to the power
supply, protected by a trip switch or a class II
insulating transformer,
characteristics:
Trip Switch
Transformer
N.B. To use the trip switches correctly, do not
forget to check that they are working properly
from time to time, by pushing the relevant button
on the front of the unit itself.
- Make sure that the section of the conductors in
the power supply cable is sized in accordance
with the starting current and length of cable. For
cables of up to 50 mt long, a section of 4 mm
sufficient.
31
GB
with the following
In 25 A Id 30 mA
230 V 50 Hz 4000 W
Continuous operation
2 is