Connecting To The Power Supply - Carat C8000 Mode D'emploi

CAUTION !
BEFORE USING A Ø 350 mm CUTTING TOOL
AGAIN, ALWAYS
POSITION OF THE CUTTING HEAD LIMIT STOP
ADJUSTER.
7 7
5. Transport
The EGO can be moved easily using the carrying
handles.
Before moving the machine make sure that:
- The sliding carriage is fixed in position by the
carriage lock.
- The motor head is completely lowered, using
the locking lever.
TO MOVE THE MACHINE:
a) Use a four-part sling, connected to the hooks in
the moving handles (photo 8).
8 8
b) The machine can easily be moved on site using
the moving wheels.
CAUTION !
IN ORDER NOT
STABILITY OF THE MACHINE, FOLLOW THE
INSTRUCTIONS BELOW CAREFULLY.
SUPPORT THE MACHINE WHILE MOVING IT.
CHECK THE CORRECT
TO COMPROMISE
With the machine in a working position:
a) Remove the moving wheels.
b) Loosen the rear legs locking knobs (motor
side).
c) Remove the rear legs one at a time.
d) Put the rear side of the machine back on the
ground.
e) Repeat the operation for the front legs.
f) Proceed to move the machine as indicated in
photo 9.
9 9

6. Connecting to the power supply

This machine must be connected to the power
supply, protected by a trip switch or a class II
insulating transformer,
characteristics:
Trip Switch
Transformer
N.B. To use the trip switches correctly, do not
forget to check that they are working properly
from time to time, by pushing the relevant button
on the front of the unit itself.
- Make sure that the section of the conductors in
the power supply cable is sized in accordance
with the starting current and length of cable.
For cables of up to 50 m long, a section of
4 mm 2 is sufficient.
THE
- Before connecting the machine to the power
socket make sure that the power supply voltage
is the same as that indicated on the machine's
plate.
27
CAUTION !
with the
In 25 A Id 30 mA
230 V 50 Hz 4000 W
Continuous operation
GB
following