Carat P-3500 Série Mode D'emploi page 37

16. Troubleshooting
THIS TOOL MUST ONLY BE REPAIRED BY TRAINED PERSONNEL
This electric tool complies with the relevant safety standards. Repairs are only to be carried out by
trained personnel, using original spare parts. Where this is not done, the user may be placed in
significant danger.
Problem
The power supply LED does not
come on.
The machine does not run and
the green running LED does not
come on.
Lubrication does not reach the
cutting tool.
The motor emits unpleasant
smells.
The motor does not start properly.
The laser marker does not work.
Cause
The power supply cable is not
properly connected or damaged.
There is no power at the socket.
The LED is damaged.
The amperometric trip switch has
tripped.
The motor high temperature trip
switch has tripped.
The excess current trip switch is
damaged.
The high temperature trip switch
is damaged.
The control switch is damaged.
The sprayer unit is clogged.
The circulation pump
damaged.
Water has filtered into the motor.
The capacitor is damaged.
The motor's bearings
damaged.
The capacitor is damaged.
The laser unit is damaged.
The marker feeder is damaged.
37
Solution
Push the plug all the way in.
Check the power supply cable.
Have the power supply socket
checked.
Contact your local dealer for a
replacement.
Press the reset pin.
Wait a few minutes for the motor
to cool down.
Contact your local dealer for a
replacement.
Contact your local dealer for a
replacement.
Contact your local dealer for a
replacement.
Remove the sprayer inside the
disc cover and clean any deposits
off of it.
is Contact your local dealer for a
replacement.
Contact your local dealer for a
replacement.
Contact your local dealer for a
replacement.
are Contact your local dealer for a
replacement.
Contact your local dealer for a
replacement.
Contact your local dealer for a
replacement.
Contact your local dealer for a
replacement.
GB