Optional Accessory - Makita LS1019 Manuel D'instruction

4
3
1
2
► 1. Upper fence 2. Lower fence 3. Clamping screw
4. Adjusting screw
NOTICE:
The lower fences are fixed to the base in
the factory. Do not remove the lower fences.
NOTICE:
If the upper fence is still loose after tight-
ening the clamping screw, turn the adjusting screw to
close a gap. The adjusting screw is factory adjusted.
You don't need to use it unless needed.
You can store the upper fences onto the holder when
not in use. Use the clip on the upper fence to hold it on
the holder.
3
► 1. Holder 2. Upper fence 3. Clip
Vertical vise
WARNING:
The workpiece must be secured
firmly against the turn base and guide fence with
the vise during all operations. If the workpiece is
not properly secured against the fence the material
may move during the cutting operation causing
possible damage to the blade, causing the material
to be thrown and loss of control resulting in serious
personal injury.
1
2
4
3
1 2
17 ENGLISH
1
2
3
4
► 1. Vise arm 2. Vise rod 3. Clamping screw 4. Vise
knob
The vertical vise can be installed in two positions on either the left or
right side of the base. Insert the vise rod into the hole in the base.
Position the vise arm according to the thickness and shape of the
workpiece and secure the vise arm by tightening the screw. If the
clamping screw contacts the carriage, install it on the opposite side
of vise arm. Make sure that no part of the tool contacts the vise when
lowering the handle all the way. If some part contacts the vise, re-po-
sition the vise.
Press the workpiece flat against the guide fence and the turn base.
Position the workpiece at the desired cutting position and secure it
firmly by tightening the vise knob.
NOTE: For a quick setting of workpiece, turning the
vise knob to 90° counterclockwise allows the vise
knob to be moved up and down. To secure the work-
piece after setting, turn the vise knob clockwise.
Horizontal vise

Optional accessory

WARNING:
Always rotate the vise nut clockwise
until the workpiece is properly secured. If the workpiece
is not properly secured the material may move during the
cutting operation causing possible damage to the blade,
causing the material to be thrown and loss of control result-
ing in serious personal injury.
WARNING:
When cutting a thin workpiece,
such as base boards, against the fence, always
use the horizontal vise.
The horizontal vise can be installed in two positions on
either the left or right side of the base. When performing
22.5° or greater miter cuts, install the horizontal vise on
the side opposite the direction in which the turn base is
to be turned.