Slide Lock - Makita LS1019 Manuel D'instruction

1
► 1. Releasing button
If you perform a bevel cut greater than 45°, move the
carriage while sliding the releasing lever toward the
front of the tool. You can perform up to 48° bevel cut.
► 1. Releasing lever
This miter saw employs positive stop function. You can
set 22.5° and 33.9° angle to both right and left quickly.
Set the latch lever in the position as illustrated and tilt
the carriage. To change the angle, pull the latch lever
and tilt the carriage.
► 1. Latch lever
CAUTION:
After changing the bevel angle,
always secure the knob.

Slide lock

To lock the sliding movement of the carriage, push the
carriage toward the guide fence until it stops. Pull the
stopper pin and rotate it 90°.
1
2
1
► 1. Unlocked position 2. Locked position 3. Stopper
pin
Switch action
WARNING:
check to see that the switch trigger actuates properly
and returns to the "OFF" position when released. Do
not pull the switch trigger hard without pressing in
the lock-off button. This can cause switch breakage.
Operating a tool with a switch that does not actuate properly
can lead to loss of control and serious personal injury.
WARNING:
ative switch trigger. Any tool with an inoperative switch is
HIGHLY DANGEROUS and must be repaired before further
usage or serious personal injury may occur.
WARNING:
by taping down or some other means. A switch with
a negated lock-off button may result in unintentional
operation and serious personal injury.
1
WARNING:
simply pull the switch trigger without pressing the lock-off
button. A switch in need of repair may result in unintentional
operation and serious personal injury. Return tool to a Makita
service center for proper repairs BEFORE further usage.
1
2
3
► 1. Switch trigger 2. Lock-off button 3. Hole for
padlock
12 ENGLISH
3
Before plugging in the tool, always
NEVER use tool without a fully oper-
NEVER defeat the lock-off button
NEVER use the tool if it runs when you