Installation - ZANKER ZKC 9244 Notice D'utilisation

Installation

• Remove the grease filters.
• Drawing a line on the wall with a pencil up to
the ceiling, corresponding to the centre line,
will make the installation operations easier.
• Apply the perforation diagram to the wall: the
vertical centre line printed on the perforation
diagram should correspond to the centre line
drawn on the wall. In addition, the lower edge
of the perforation diagram corresponds to the
lower edge of the hood.
64
• Make holes as indicated on the template,
insert the wall dowels and screw 2 screws
into the upper holes, leaving a space of about
1 cm between the head of the screw and the
wall..
Note: Always make the holes indicated on the
template. The upper 2 are for hooking the
hood up while the lower holes (generally 2
lateral) are for the definitive and safety fixing.
• Apply flues support bracket to the wall
touching the ceiling. Use the flues support
bracket as a perforation diagram (the small
slot in the support must coincide with the line
previously drawn on the wall, if present), and
mark two holes with a pencil. Make the holes
and insert 2 dowels.
Ø 8
5x45
Ø 8
Ø 8