Safety Instructions; General Safety; Operating The Device Safely - Dometic Waeco ECL-76 Instructions De Montage Et De Service

ECL-76, ECL-102, ECL-103
2

Safety instructions

The manufacturer accepts no liability for damage in the following cases:
 Damage to the product resulting from mechanical influences and excess voltage
 Alterations to the product without express permission from the manufacturer
 Use for purposes other than those described in the operating manual
2.1

General safety

WARNING!
!
 Always disconnect the power supply when carrying out repairs on the charg-
ing current distributor.
 If a connection cable is damaged, it must be replaced to prevent possible
electrical hazards.
 Do not operate the device if it is visibly damaged.
 This device may only be repaired by qualified personnel. Inadequate repairs
can cause considerable hazards.
If your device should need repairing, please contact your specialist dealer.
 People (including children) whose physical, sensory or mental capacities or
whose lack of experience or knowledge prevent them from using this product
safely should not use it without the supervision or instruction of a responsible
person.
 When installing the charging current distributor, ensure that it will be out of the
reach of children.
2.2

Operating the device safely

WARNING!
!
 Do not operate the device near flames or other heat sources (heating, direct
sunlight, gas ovens, etc.).
 Never immerse the device in water.
 Protect the device and the cable against heat and moisture.
 To prevent short circuits, always disconnect the negative terminal of the ve-
hicle battery before working on the vehicle electrical system.
If the vehicle has an additional battery, its negative terminal should also be
disconnected.
 Inadequate cable connections can cause short circuits, resulting in:
– Cable fires
– The airbag being triggered
– Damage to electronic control equipment
– Electrical malfunctions (indicators, brake light, horn, ignition, lights)
EN
Safety instructions
73