Eject The Memory Card; Connect The Headset; Attach The Wrist Strap; Antennas - Nokia E Série Mode D'emploi

Set up your device
2. Insert the memory card in the slot with the contact area
first. Make sure that the contact area is facing the
connectors on the device.
3. Push the card in until it locks into place.
4. Close the cover.

Eject the memory card

Important: Do not remove the memory card in the
middle of an operation when the card is being accessed.
Removing the card in the middle of an operation may damage
the memory card as well as the device, and data stored on
the card may be corrupted.
1. Press the power key briefly, and select
card.
2. Open the cover of the memory card slot.
3. Press the end of the memory card to release it from the
memory card slot.
4. Close the cover.
18

Connect the headset

hear outside sounds may be affected. Do not use the headset
where it can endanger your safety.
Connect the compatible headset to the headset connector of
your device.

Attach the wrist strap

Thread the wrist strap as shown, and tighten
it.
Remove memory

Antennas

Your device may have internal and external antennas. As with
any radio transmitting device, avoid touching the antenna
area unnecessarily while the antenna is transmitting or
receiving. Contact with such an antenna affects the
Warning: When you use the headset, your ability to
© 2008 Nokia. All rights reserved.