Danby Designer DPAC120011H Guide D'utilisation Et Soins De Propriètaire page 15

Installation Instructions
INSTALLATION IN A
SLIDING SASH
WINDOW
1. Cut the foam seal (adhesive type) to the proper length and attach it to
the window frame. See Fig.12.
2. Attach the window slider kit to the window stool. Adjust the length of
the window slider kit according to the height of window, shorten the
adjustable window kit if the height of window is less than 26.5 inches.
Open the window sash and place the window slider kit on the window
stool. See Fig.13.
3. Cut the foam seal (adhesive type) to the proper length and attach it on
the top of the window. Shown in Fig.14.
4. Close the sliding sash securely against the window.
5. Cut the foam seal to an appropriate length and seal the open gap
between the top window sash and outer window sash. Shown in
Fig.15.
Window
Panel
Foam
Seal
14
Foam seal A
(adhesive type)
Fig.12
Fig.13
Fig.14
Fig.15