ERRECOM PureZone Machine Manuel D'utilisation page 11

USE OF PUREZONE MACHINE INSIDE VEHICLES
For vehicles COMPACT VEHICLES - SALOON CARS - STATION WAGONS
For vehicles SUV - SPACE WAGONS - COMMERCIAL VEHICLES - MINIBUS - MOTOR HOMES
•
•
•
•
•
WARNING
•
1
Start engine and place PureZone Machine on the floor mat at
the passenger side and set the conveyor tube as much closer
as possible to the recirculation air intake.
3
Set A/C system temperature at 22°C and select front
ventilation.
5
13
Set the air fan on intermediate speed.
Reproduction, even partial, in any form of this handbook without prior written consent by ERRECOM srl is strictly prohibited.
ERRECOM srl reserves the right to improve or modify its equipments at any time and without prior notice.
use one dose of CAREZONE of 120 ml
use one dose of CAREZONE of 220 ml
The device automatically switches off at the end of the treatment.
If the cabin filter is located inside the vehicle cockpit, take it away.
If the cabin filter is located in the front of the vehicle, under the bonnet, it is not necessary
to take it away.
Clean the vehicle and take the carpets away from the cockpit.
At the end of the operation open all doors, stop engine and ventilate the cockpit for
approximately 5-10 minutes.
ALWAYS replace the cabin filter after the sanitising treatment.
2
Place the supply cable through the door and completely
close all windows and doors of the vehicle.
4
Select internal air recirculation mode.
6
Open all air flows of the dashboard.
D
E
USO
EN
IST.AB1032.01