ERRECOM PureZone Machine Manuel D'utilisation page 10

Connect PureZone Machine to the power supply
Air Conditioning & Refrigeration Solutions
HIGH
TEMPERATURE
®
100 ML 200 ML
START/STOP START/STOP
230 V 50/60 H
AC
ERRECOM srl
Via Industriale, 14
25030 Corzano (Brescia) ITALY
Tel. +39 030 9719096
www.errecom.it
1. After pouring one dose of the liquid CareZone (120 or 220 ml), the two READY/ON green leds start to flash.
2. In case too much liquid is poured inside PureZone Machine and maximum level is exceeded, HIGH LEVEL red
led will start flashing (warning for excess) and nebulisation will be blocked.
3. Pressing START/STOP button 100 ml (in case you use the dose of 120 ml) or START/STOP button 200 ml (in
case you use the dose of 220 ml), the device is automatically set on a minimum operating time of 11 minutes.
4. When PureZone Machine starts nebulising the READY/ON green led stops flashing and stays fixed.
5. If the internal temperature reaches more than 65°C the device stops nebulising and the HIGH TEMPERATURE
red led switches on (warning of high temperature), but the fan will keep working.
6. Nebulisation will restart when the temperature will recover under 60°C and the HIGH TEMPERATURE red led will
switch off.
EN
IST.AB1032.01
PREPARATING PUREZONE MACHINE
Connect the specific conveyor tube to PureZone Machine
DIRECTIONS CONTROL PANEL
HIGH
LEVEL
Z
START/STOP
button
Reproduction, even partial, in any form of this handbook without prior written consent by ERRECOM srl is strictly prohibited.
ERRECOM srl reserves the right to improve or modify its equipments at any time and without prior notice.
Pour inside the nebulizer the liquid CareZone
HIGH
TEMPERATURE
HIGH TEMPERATURE
red led
HIGH
LEVEL
HIGH LEVEL
READY/ON
green led
red led