General Safety Instructions; Overview Of The Components; Start-Up Of The Device/Introduction; Instruction Manual - AEG SRR 4301 Mode D'emploi

General safety instructions

To avoid the risk of fi re or an electric shock, you should
not expose the device to rain or moisture. Consequently,
do not use the device in the immediate vicinity of water
- for example near a bath tub, a swimming pool or in a
damp cellar.
Use the device only for the intended purpose.
Only connect the device at a properly installed plug
socket. Pay attention that the specifi ed voltage corres-
ponds to the voltage of the plug socket.
When using external mains supply, pay attention to the
correct polarity and voltage. Always place the batteries
in the correct direction.
Assemble the device in such a way that the available
ventilation openings are not covered.
Never open the housing of the device. Incorrect repairs
can constitute a considerable risk for the user. Should
the device become damaged, in particular the mains
supply cable, do not operate the device any longer, but
rather have it repaired by an expert. Check the mains
supply cable regularly for damage.
For safety reasons a broken or damaged mains lead may
only be replaced by an equivalent lead from the manuf-
acturer, our customer service department or a similary
qualifi ed person.
If the device is not used for a longer period, remove the
plug connector from the plug socket or take out the
batteries.
These symbols may be found on the machine and are
intended to indicate the following:
The lightning symbol should advise the user
of parts in the inside of the device which carry
dangerously high voltage levels.
The symbol with an exclamation mark should
advise the user of important operation or
maintenance instructions in the accompa-
nying documentation.
Devices bearing this symbol work with a
„class 1 laser" for tracing the CD. The built-in
safety switches should prevent the user being
exposed to dangerous laser light, which is
invisible to the human eye, when the CD compartment
is opened.
Under no circumstances should these safety switches
be bypassed or manipulated, as this could result in a
danger of exposure to the laser light.
5....-05-SRR 4301 AEG 25

Overview of the Components

1 Function keys - cassette
a b Recording key - cassette
b Playback key - cassette
c Fast Rewind key - cassette
d Fast Forward key - cassette
e / Stop/Eject key - cassette
f II Pause key - cassette
2 CD STOP button
3 Volume display
4 REPEAT button
5 PROGRAM button
6 CD Display
7 Cassette compartment
8 FM/ST control lamp
9 + / - SKIP buttons (forward/reverse search)
10 / II CD PLAY/PAUSE button
11 Tab for opening the CD compartment
12 Station scale
13 Handle
14 CD compartment
15 TUNING control
16 BAND selector switch (FM ST/FM/AM)
17 PHONES headphone connection
18 Battery compartment
19 AC connection
20 POWER switch (AC/DC)
21 On/off switch (ON OFF)
22 FUNCTION selector switch
(CD / TAPE / OFF / TUNER)
23 VOLUME
24 Aerial

Start-up of the device/Introduction

• Please read the operating instructions carefully
before using the radio recorder for the fi rst time!
• Select a suitable location for the radio recorder, such
as a dry, fl at, non-slip surface on which it is easy to
operate the machine.
• Ensure that the radio recorder is suffi ciently ventila-
ted!
Power supply
• Insert the mains plug (e.g. battery compartment (18))
into a correctly installed 230 V, 50 Hz power socket.
Ensure that the voltage is the same as that indicated
on the model identifi cation plate.
• Turn the machine on by the switch (21).
• Please ensure that during mains operation the
POWER switch (20) on the back is turned to AC, and
during battery operation to DC.
Inserting the Batteries
(not supplied)
• Open the lid of the battery compartment (18) on the
back.
• Insert 8 batteries of type UM2/R14 1,5V. Ensure that
the polarity is correct (See imprint on the outside)!
• Close the battery compartment, making sure not to
trap the mains lead.
• If you do not use the machine for a prolonged period,
remove the mains plug from the socket and remove
the batteries in order to prevent battery acid from
leaking.
25
30.01.2004, 9:04:33 Uhr