Varian TV 141 Notice De Mode D'emploi page 13

INSTALLATION
The following figure shows the various components of
the TV 141 Navigator
components come disassembled and it is therefore up
to the customer to assemble the kit.
O-ring
Valve/coil
Output connector
Kit Components
!
When assembling the kit be careful not to unscrew
the coil securing ring and nut inside the valve.
Once the kit is assembled, install it on the pump.
Remove the screw cap from the pump, then secure the
valve to the pump using a 16 mm wrench making sure
to tighten the nut with a torque equivalent to 2.5 Nm.
The following figure shows an example of installation.
Vent Valve kit. These
Adapter
Air filter
Valve-controller cable
Control unit pump controller
connection cable
Valve control unit
Input connector
WARNING
Valve
Control unit
Connection
cables
To avoid damaging the pump, do not tighten the
nut with a torque greater than 2.5 Nm.
Upon completion of the mechanical installation, attach
the connection cable between the valve to the control
unit, and the connection cable between the electrovalve
control unit to the pump's controller.
Use the velcrose provided to secure the controller box.
8
INSTALLATION PROCEDURE
Installation
!
WARNING
87-900-911-01 (C)