Ryobi RCS5133CB Traduction Des Instructions Originales page 5

back toward the operator. Either of these reactions may
cause you to lose control of the saw, which could result
in serious injury. Do not rely exclusively upon the safety
devices built into your saw. As a chainsaw user, you
should take several steps to keep your cutting jobs free
from accident or injury.
1. With a basic understanding of kick-back, you can
reduce or eliminate the element of surprise. Sudden
surprise contributes to accidents.
2.
the engine is running. Place your right hand on the rear
handle and your left hand on the front handle with your
maintain control of the saw if kick-back occurs.
3. Make sure that the area in which you are cutting is free
from obstructions. Do not let the nose of the guide bar
contact a log, branch, fence, or any other obstruction
that could be hit while you are operating the saw.
4. Cut at high engine speeds. Always cut with the engine
running at full speed. Fully squeeze the throttle trigger
and maintain a steady cutting speed.
5. Do not overreach or cut above chest height.
6. Follow the manufacturer's sharpening and maintenance
instructions for the saw chain.
7.
manufacturer or the equivalent.
NOTE: Refer to "Operation" in this manual for information
on kick-back and how to avoid serious personal injury.
WHITE FINGER RISKS
Prolonged use of chainsaws expose operators to harmful
numbness and tingling. In extreme cases, it will cause loss
of touch sensation.
Anti-vibration system does not guarantee that you will not
should seek medical advice immediately.
SYMBOL
Some of the following symbols may be used on this
product. Please study them and learn their meaning.
Proper interpretation of these symbols will allow you to
operate the product better and safer.
Safety alert
To reduce the risk of injury, user must
read and understand operator's manual
before using this product.
Wear eye, hearing and head protection
when operating this equipment.
English
Wear non-slip, heavy-duty protective
gloves when handling the chainsaw.
Hold and operate the saw properly with
both hands.
Do not operate the saw using only one
hand.
Danger! Beware of kickback.
Danger! Beware of kickback.
Avoid bar nose contact.
Use unleaded petrol intended for motor
vehicle use with an octane rating of 91
([R+M]/2) or higher.
Use 2-stroke oil for air cooled engines.
Mix the fuel mix thoroughly and also
each time before refueling.
Add bar and chain oil every time you
add fuel to the chainsaw.
Mix fuel outdoors where there are no
fuel tank.
CE conformity
GOST-R Conformity
Guaranteed sound power level is 114
dB.
Set the chain brake to the RUN
position.
Set the chain brake to the BRAKE
position.
Turn ignition switch to the ON position.
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
3