Publicité
Les langues disponibles
Les langues disponibles
- Belt is too tight.
Plug the unit into a wall socket with an
EARTH terminal. Set switch (L) to
Position [1].
ASSEMBLY INSTRUCTIONS.-
The assistance of a second person
is advisable for the assembly work.
Take the unit out of the box and place
it on the floor as shown in Fig.0.
Make sure that all of the pieces are
there: (1) Main structure; (44) Side bar
base cover (Left); (45) Side bar base
cover (Right); (46) Side supports; (23)
Combination box spanner; (24) Spanner
with star screwdriver; (142) Allen key
6mm; (69) Screw M-6x20; (87) Screw
M-5x16; (106) Safety key; (119) Bottle
of
lubricant; (113) Mains
Follow the instructions step by step to
assemble:
1.- First loosen the two top holding
knobs (22) by two turns, anticlockwise,
Fig.1, next take hold of the handrails
(9 and 10) and lift them in the direction
of the arrow, as shown in Fig.2, until
you hear the top holding knobs (22)
click into position.
2.- Now loosen off the bottom holding
knobs by two turns (22) Fig.3.
Holding the handrails (9 and 10), lift
the focus bars in the direction of the
arrow, see Fig.4, until you hear the
bottom holding knobs (22) click into
position.
NOTE: Make sure that you hear the
top holding knobs click into the
Fig.B
cable.
handrails and the bottom knobs click
into the focus bars before you let go of
the handrails.
3.- Once you have completed the
above, tighten the top knobs (22)
securely,
Fig.5,
clockwise and the bottom knobs (22)
Fig.5, by turning it clockwise.
FITTING THE SIDE SUPPORTS.-
Bring the side support (46) up to the
main structure (1), positioning it on the
holding pins, as shown in Fig.6.
Next, use the spanner (23) to tighten the
screws (69) on to the foot rest, Fig.6.
Now perform the same assembly
operation with the other foot rest.
FITTING THE BASE COVERS.-
Position the left and right base covers
(44) and (45) in the direction of the
arrow facing the corresponding side
bar, as shown in Fig.7 and attach
them by using screws (87), as shown
in Fig.7.
FITTING THE HAND RESTS.-
First take the combination box spanner
(23) and loosen screw (66), located on
the base of the hand rests (9 and 10), a
few turns in an anticlockwise direction,
Fig.8 position I.
Now rotate the hand rests (9 and 10)
in the direction of the arrows, Fig.8
position I.
Once the hand rests are positioned,
use the box spanner (23) to retighten
screws (66) securely, Fig.8 position II.
ATTENTION: Cylinder (21) Fig.9 is
factory set to high pressure so it must
not be knocked. If it is knocked this
may
damage
operation of the treadmill.
19
by
turning
it
and
impair
them
the
Publicité
