Software Installation; System Requirements; Usb Driver Installation; Graphic Editor Installation - Ecler DPM3003 Notice D'emploi

4. SOFTWARE INSTALLATION

4.1. System requirements

.amiclab-m3 needs a PC with Windows® 98SE/ME/2000/XP/VISTA (a Pentium III 600MHz or
more with 128 MB of RAM or greater is recommended), a USB port (1.1 or 2.0), and a VGA video card
with a minimum 800x600 resolution (1024x768 recommended). The computer doesn't act upon audio
processor efficiency, since all processing is done inside DPM3003 DSP. It is only used to graphically edit
parameters.
Before being able to use .amiclab-m3 to communicate with DPM3003, you have to install the
USB driver. This driver allows the PC to recognize DPM3003, and gives .amiclab-m3 a method to
communicate with the hardware.

4.2. USB driver installation

In order to install the USB driver, you'll need "amicusb.inf" and "amicusb.sys" files from
.amiclab-m3 CD-ROM:
1. Connect the USB cable between DPM3003 and the computer. A "Found New Hardware Wizard"
window will appear.
2. Select "Install from a list or specific location" and browse to the right files path.
The wizard will automatically install the driver.

4.3. Graphic editor installation

1. Run the "setup_amiclab_m3.exe" file and follow installer instructions.
2. .amiclab-m3 will be installed in a folder named "\Program Files\amiclab-m3" in the hard disk.
During the installation, you can choose a different location (folder) for the software.
3. Confirm each installation process window by clicking on "Next" button. Installation may be
cancelled at any time by clicking on "Cancel" button.
4. When the installation is complete, click "Finish" to go back to Windows® desktop or to
automatically launch .amiclab-m3 if "Launch .amiclab-m3" option has been chosen.
7