Velleman VRC1601D Notice D'emploi page 6

a. Learning a Command
• Press the device key you would like to learn a command
to.
• Hold the SET key pressed for 3 seconds.
• Select LEARNING using the or the button and
press OK.
• Select LEARNKEY using the
or the button and
press OK. The LCD will display SELECT KEY.
• Select the target key you want to learn the command
(e.g. power) to. The LCD will display PLS SEND
SIGNAL IN.
• Point the IR sensor of the VRC1601D towards the IR
sensor of the other remote control (max.
distance of 5cm).
• Hold the original key on the other
remote control pressed until the LCD
of the VRC1601D reads SUCCESS.
Repeat the 3 steps above if the LCD
displays FAILED or to learn another
command.
Remark: - When transferring multiple commands to the same target button, the VRC1601D will only save the last programmed command.
- All functions are transferable.
- This remote control accepts up to 100 codes for a total of 8 devices. However, it may not accept some codes.
b. Deleting a Learned Command of a Device
• Press the device key you would like to delete a
command from.
• Hold the SET key pressed for 3 seconds.
• Select LEARNING using the
or the button and
press OK.
• Select DELETE KEY using the
or the
press OK. The LCD will display SELECT KEY.
• Press the key you would like to delete. SURE DELET
will appear on the LCD. Press OK to confirm. SUCCESS
will be displayed.
• Repeat the step above for each key you would like to delete. Press a device key to exit the delete mode.
c. Deleting All Learned Commands of a Device
Use this function to delete all the commands of a device instead of deleting all the commands one by one.
• Press the device key you would like to delete the
commands from.
• Hold the SET key pressed for 3 seconds.
• Select LEARNING using the or the button and
press OK.
• Select DELETE DEV using the
or the
press OK. The LCD will display SELECT DEV.
• Select the device you would like to delete using the
corresponding device key. Press OK.
• SURE DELET appears on the LCD. Press OK to confirm.
• Repeat the two steps above if you would like to delete
the commands from another device.
• Press EXIT to quit.
VRC1601D
button and
button and
6 VELLEMAN