Sequenced Dispensing Mode (Sd) - Biohit Proline XL Mode D'emploi

10. To dispense, position the tip, press either of the START buttons and
repeat until the cycle is complete.
Note: To avoid dripping, the XL will automatically aspirate a small
amount of air after each dispensing.
11. Finally, position the tip to discard any remaining excess and press the
START button twice.
Note: The dispensing can be interrupted by pressing "E". An ARROW
DOWN and E appear on the display. Pressing either of the START buttons
twice will empty the pipette/tip.

5.6. Sequenced Dispensing Mode (Sd)

A series of different volumes can be delivered in any desired order.
1. Press
2. Confirm the mode change by pressing
3. The first dispensing volume appears in the display. If this mode
has been used before the previous settings appears in the display.
Press
4. Select the first desired dispensing volume onto the display by using
the and
5. Press
6. To select the following dispensing volumes (up to xx) use the
and
selection by pressing the
7. To confirm your final selection press
8. Position the tip to aspirate and press either of the START buttons.
9. Position the tip to discard priming excess and press either of the START
buttons again.
10. Position the tip to dispense and press either of the START buttons. Repeat
the action until the cycle is complete.
Note: To avoid dripping, the XL will automatically aspirate a small amount
of air after each dispensing.
11. Position the tip to discard any remaining excess and press START twice.
12
to display
to start the operation or
.
to confirm the desired dispensing volume.
buttons, always remembering to confirm each
.
to change the volume.
button.
.
.