Installation And Configuration - B.A. International BA-Optima 10 BASES10 Manuel D'utilisation

BA Optima 10 IFU.qxp_Layout 1 13.11.17 09:22 Seite 5

Installation and configuration

Installation of the optical fiber:
Insert the optical fiber in the hole of the body, push it into the body with a soft twist.
Handle the optical fiber with care, it is fragile.
Installation of the shade
Insert the shade on the end of the optical fiber.
Configuration and function
1. Charging
Open the box, take the charger and adaptor out, connect the adaptor with AC
100v ~ 240v power, and connect the DC output plug of adaptor to the DC input
plug of charger, then put the mainframe into the socket of the charger. The
power indicator normally lights up in red during charging and turns green when
fully charged. Charging the device the first time should take about 6 ~ 7 hours
maximum. The charger should be taken out of the socket when fully charged.
2. Operation
P Power Key
M Mode Key
T Time Set
01 Full Power Mode
02 Progressive Mode
Installation and configuration
03 Pulse Mode
1. In order to ensure good contact, tighten the body and battery. The unit then
tests itself automatically with a buzzer as it automatically goes into "01" mode
for 20 seconds.
2. Press the mode key to choose: the LED display will be showing the correspon-
ding mode.
3. Press the start button to start working, there is a buzzer every 5 seconds as an
interval and the curing light goes off when working time has ended. You can
use it once again by pressing the start button whereafter you can choose the
mode by pressing mode key.
Automatic power off: when the unit stays inactive for 2 minutes, it will turn
off automatically.
Continuous mode: full power
Ramping mode: power increase stronger continually
Pulse mode:
The light flashes during 1 second within the working time.
5