Use - DS Produkte 01774 Mode D'emploi

Use

PLEASE NOTE!
■ Empty and clean the collecting container after each use or when the maximal fi ll level
(MAX marking) is reached. Do not overfi ll the collecting container! Liquids must
not get into the ventilation opening during use!
■ Test the wiping attachment on a non-visible spot before using it on sensitive (high-
gloss) surfaces.
■ Never clean screens (televisions, computer monitors etc.) with the device. Electrical
devices of this type are not resistant to moisture.
■ Do not insert anything into the ventilation openings of the device and make sure that
these do not become clogged.
■ Do not use the device when it is connected to the mains power supply.
1. Insert the nozzle you want into the suction opening (5) (see the "Attaching / Remov-
ing Nozzles" chapter).
2. Make sure that all parts are attached correctly to the device (see the "Device Over-
view" chapter).
PLEASE NOTE: Make sure before the cleaning process that the silicone plug (16)
of the insert (14) is plugged as far as it will go in the opening! Otherwise water could
run into the insert.
6. To ensure optimum performance of the device, empty the collecting container after
every use (see the "Cleaning and Storage" chapter) and charge up the battery (see
the "Charging Up the Battery" chapter).
Cleaning Windows and Other Smooth Surfaces
1. Fill the spray bottle (14): Unscrew the spray head from the spray bottle and fi ll the
bottle with cleaning agent. Dilute the cleaning agent with water if necessary. Note the
instructions for the cleaning agent when you do this.
d
c
23
3. Press the On / Off switch (2) to switch on the device.
4. Guide the nozzle over the surface to be cleaned. Check
regularly during use whether the MAX marking in the col-
lecting container (4) has already been reached.
5. Switch off the device after you fi nish cleaning each surface
to increase the operating time on each battery charge. To
do this, press the On / Off switch again in order to switch
off the device.
2. Place the wiping attachment (a) on the spray head. Press
the fi xing ring (b) against it from below so that these two
components are fi xed against one another.
a
3. Stretch the wiping cloth (d) on the wiping attachment and
fi x it in place with the Velcro fastener.
b
4. Close the spray bottle.
5. Press the spray lever (c) to spray the cleaning agent even-
ly over the surface which is to be cleaned.
6. Detach the dirt using the wiping cloth.
EN