Fitting The Electrode/Sensor - Mettler Toledo InTrac 787 Instructions D'utilisation

InTrac ® 787
4.2.2

Fitting the electrode/sensor

1
3
5
1. Pull out the immersion tube.
2. Close the ball valve.
3. Disconnect the immersion tube right at the ball valve.
4. Disconnect the electrode holder by turning it counterclock-
5. Disconnect the electrode cable.
6. Remove the electrode.
7. Check washers and O-rings on electrodes for damage
8. Remove watering cap from electrode tip and rinse electrode/
9. Carefully insert the electrode into the electrode holder and
10. Re-Install the complete housing.
© 05/10 Mettler-Toledo GmbH, CH - 8606 Greifensee
Printed in Switzerland
wise.
and replace if necessary.
sensor with water.
screw in by hand as far as it will go.
Important: use no tools!
2
4
6
11
7
InTrac 787-01-CH
52 402 481