State Of California Proposition 65 Warnings; Causes For Damages; Protecting The Environment; General Notes - Bosch HCP30651UC Instructions D'installation

Masquer les pouces Voir aussi pour HCP30651UC:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

State of California Proposition 65
Warning
WARNING
This product can expose you to chemicals including
vinyl chloride, which is known to the State of California
to cause cancer and birth defects or other reproductive
harm.
For more information go to www.P65Warnings.ca.gov.

Causes for damages

CAUTION
9
Risk of damage due to corrosion. Always turn
appliance on when cooking to avoid condensation
buildup. Condensation can lead to corrosion
damages.
Always replace burnt out bulbs immediately to avoid an
overload of the remaining bulbs.

Protecting the environment

Unpack the appliance and dispose of the packaging in
line with environmental requirements.

General notes

Fan operation

Note: Ventilation may not exit through an already
operational smoke or exhaust chimney, nor a duct used
for ventilating furnace installation areas.
If the ventilation is intended to pass through a smoke
or exhaust that is not in operation, the responsible
area heating inspector must give approval.
If the ventilation passes through an external wall, use a
telescope wall sleeve.

Ventilation line

Note: The manufacturer is not responsible for any issues
associated with the pipe section.
The device achieves its optimum performance by
means of a short, straight exhaust air pipe and as
large a pipe diameter as possible.
The optimum extraction performance is not achieved
and fan noise is increased if exhaust air pipes are long
and rough and if there is a large number of pipe bends
or diameters less than 8" (203 mm).
The pipes or hoses for laying the exhaust air line must
consist of non-combustible material.
Risk of damage due to the presence of humidity into the
electronic circuitry. Never clean operator controls with a
wet cloth.
Surface damage due to incorrect cleaning. Clean
stainless steel surfaces in the grain direction only. Do not
use any stainless steel cleaners for operator controls.
Surface damage due to strong or abrasive cleaning
agents. Never use strong and abrasive cleaning agents.
Risk of damage from condensation back flow. Install
exhaust vent at a slight downward slope away from the
appliance (1° slope).
Round pipes
An inner diameter of 8 " (203 mm) is recommended.
7

Publicité

Table des Matières
loading

Table des Matières