Technical Properties - Olympia CPD 425 Mode D'emploi

Changing the ink ribbon
When the print is faded, change the ink ribbon!
Æ Switch the calculator off.
Æ Open the top cover by pushing it back. (Fig. 1).
Æ Remove the old ink ribbon by pulling it up. (Fig. 2).
Æ Insert the new ink ribbon and press it carefully until it
engages. IR-40 (Fig. 3).
Æ When the ink ribbon is positioned correctly, slide the
housing cover back on and insert the leading edge of pa­
per. (Fig. 4).
6
Inserting the paper roll
ATTENTION!
• Damage to the print head
Æ Never actuate any keys (except the Paper
Feed key) when the printer is switched on.
Æ Open the top cover by pushing it back.
Æ Pivot the paper roll holder out.
Æ Cut the leading edge of the paper roll straight using a
pair of scissors.
Æ Guide the leading edge of the paper through the open­
ing on the rear side of the calculator and slide the leading
edge in the slit in the calculator.
Æ Mount the paper roll on the paper roll holder.
Æ Press the Paper Feed key until the leading edge of the
paper roll comes out of the top section of the calculator.
Æ Thread the leading edge of the paper through the
opening in the housing cover and slide the cover back on
.

Technical properties

Power supply
Power adapter
plug
Power consump­
tion
Display
Dimensions
(L x W x H)
Ink ribbon
Paper roll
Power adapter plug or 4 AA
batteries (R6)
6 V , 300 mA
DC
1.8 W
12 characters
199 mm x 102 mm x 44 mm
IR-40
Width: 57 mm
Diameter: 50 mm to 80 mm