Festool CTM 26 E Notice D'utilisation Originale page 17

If the mobile dust extractor will not switch
on again, please contact a Festool service
workshop.
7.7 Changing the filter bag (SC FIS-CT
26/36/48)
Removing the filter bag [4]
► Open the locking clips [2-2] and remove the
top section of the machine[2-1].
► Remove the filter bag.
► Dispose of the used filter bag in accordance
with statutory regulations.
► Clean the dust container [2-3].
Inserting the filter bag [5]
► Insert a new filter bag (SC FIS-CT 26/36/48)
in the inlet port of the dust container and in­
terlock it. Important: be aware that the
locking engages.
► Replace the top section [2-1] and close the
locking clips [2-2].
Make sure that the filter bag is not pinched
between the top and bottom sections.
7.8 Changing the disposal bag
Removing the disposal bag [6]
► Close off the extractor opening [1-2] using
the sealing plug [1-1].
► Open the locking clips [2-2] and remove the
top section of the machine [2-1].
► Close the disposal bag.
► Remove the disposal bag.
► Dispose of the used disposal bag in accord­
ance with statutory regulations.
► Clean the dust container [2-3].
Inserting the disposal bag [7]
► Insert a new disposal bag (ENS-CT26/36/48)
on the inlet nozzle of the container and lock
in position.
Possible causes
Value set on the suction power adjust­
er [1-10] is too low.
Rotary knob [1-9] not set to the correct
hose diameter.
Suction hose blocked or kinked.
Filter bag full.
Filter element clogged.
Important: The lateral openings on the dis­
posal bag must be positioned inside the
container. Make sure that the bolt engages.
► Place the disposal bag over the edge of the
container.
Make sure that the contacts [10-2] are
free.
► Replace the top section [2-1] and close the
locking clips [2-2].
7.9 Volumetric flow monitoring
An acoustic warning signal sounds if the air
speed in the suction hose falls below 20 m/s (at
dust class 'M',).
The table on the mobile dust extractor ex­
plains this connection for the minimum re­
quired extraction volume of the respective
hose diameter. If the rate is below the re­
spective extraction volume, a warning sig­
nal is emitted.
* only for EU versions of CT AC
Solution
Set the suction power adjuster to a higher value (see
Chapter 7.4).
Set the knob to the correct hose diameter (see Chap­
ter 7.1 ).
Remove blockage or kink.
Insert a new filter bag (see Chapter 7.7 ).
Change the filter element (see Chapter 9.1).
Only AUTO Clean : clean filter element (see chap­
ter 8.2).
English
17