Hauff-Technik HRD 80-FUFA/o/u Instructions De Montage page 27

HRD (D)-Z-FUF/FUFA-KMB
3 Description: Z-HRD (D)-FUF/FUFA-KMB accessory set
– For waterproofing of buildings with waterproof sheeting or thick coatings that come into contact with
the ground, proceed with fixed/loose flange according to DIN 18195 Part 9: 2010-05 for a sealing
made from a polymer-modified bituminous thick coating (KMB) or waterproof sheeting according
to DIN 18195 Part 2: 2009-04 against standing seepage water and pressing water according to DIN
18195 Part 6: 2011-12 (ref. as black tank).
– When using galvanised flanges, a 2K epoxy resin coating and sanding are to be provided on site for
all KMB contact surfaces.
– Attention should be paid here to the laying guidelines of the sheeting manufacturers or KMB manufacturers.
4 Scope of delivery
The scope of delivery for the Z-HRD (D)-FUFA-KMB includes:
– Sealing fleece
– 2 mm EPDM rubber inlay
5 Required tools and auxiliaries
To install the Z-HRD (D)-FUFA-KMB correctly, you will need the following tools and auxiliaries in addition to
the usual tools:
– trowel
– brush
– rag
Torque guidelines from sheeting manufacturers/DIN 18195
for tightening loose flanges
Type of entry sheeting/thick coating
When using Hauff Z-HRD (D)-FUFA rubber inlays
For KMB (polymer-modified bituminous thick coatings) in conjunction with
Hauff rubber inlays
Bare bitumen sheeting according to DIN 52129-R 500
PIB bonded with bitumen
Bitumen and polymer bitumen sheeting according to DIN 18195-2: 2009-04,
Table 3, with glass fabric reinforcement
Bitumen and polymer bitumen sheeting according to DIN 18195-2: 2009-04,
Table 3, with polyester fleece or copper strip reinforcement
R 500 N + 1 Cu
ECB, PVC-P, elastomer and EVA sheeting according to DIN 18195-2: 2009-04,
Table 4, bonded with bitumen
R 500 N + 2x Cu
Plastic sheeting according to DIN 18195-2: 2009-04, Table 4, loosely laid
– Silicone caps
– Installation instructions and general appraisal
certificate from the KMB manufacturer
27
Torque for Torque for
M12 (Nm) M20 (Nm)
30
30
12
12
15
20
20 1st tightening: 100
20
1st tightening: 120
30 2nd tightening: 100
3rd tightening: 80
30
GB
80
100
50
50
65
80
80
100