Connections; Connecting Input/Output Terminals - PIONEER DJ XDJ-RX2 Mode D'emploi

Connections

! Connect the power cord to a power outlet after all the connections are completed.
! Turn off this unit and disconnect the power cord from the power outlet before connecting components or changing the connections.
! Refer to the operating instructions for the components to be connected.
! Be sure to use the supplied power cord.
! Connect this unit and the computer directly using the included USB cable.

Connecting input/output terminals

Rear panel, front panel
Headphones
Power amplifier,
powered speakers,
etc.
R L
1
Front panel
1 PHONES terminals
2 MASTER1 terminals
! Be careful not to accidentally insert the power cord of
another unit to [MASTER 1] terminal.
! Do not connect the terminal that can supply phantom
power to the [MASTER 1] terminal.
3 MASTER2 terminals
4 BOOTH terminals
5 Kensington security slot
USB terminal
6
This product satisfies electromagnetic noise
regulations when it is connected to other equipment
through shielded cables (with Ferrite-cores attached)
and connectors.
Use only the furnished accessory connecting cables.
The ferrite-cores are for the purpose of preventing
electromagnetic noise, do not remove them.
7 LINE/PHONO terminals
8 AUX terminal
10
En
Power amplifier,
powered speakers, etc.
Power amplifier
(for booth monitor)
R L
R
2 3 4 5
Rear panel
D44-8-1-2b_A1_En
D44-8-1-4_A1_En
Computer
Portable audio device
DJ
software
DJ player
DJ player
L
L
L R
6 7 7 8
9 SIGNAL GND terminal
a MIC2 terminal
b MIC1 terminal
c AC IN
Analog player
Microphone
R
R L
9 a b
Microphone
To power outlet To power outlet
Power cord Power cord
c