Before You Begin (1)
Power Cord and Foot Controller
WARNING
Please use common household
current.
Plug in cord.
●
Plug foot controller into machine.
●
When you press the foot controller
●
down lightly, the machine will run
at a low speed. When you press
harder, the machine's speed will
increase. When you take your foot
off the foot controller, the machine
will stop.
Power Switch
Flip power switch to "I" position
●
to turn on.
To switch power off, flip switch to
●
"O" position.
Thread Tension Dial
When tighter thread tension is
●
desired, turn the tension dial
to the right. Upper and bobbin
threads will meet on right side of
the fabric.
When looser thread tension is
●
desired, turn tension dial to the
left. Upper and lower threads
will then meet on wrong side of
fabric.
Power Cord
Foot Controller
Slower
Faster
Power Switch
Upper Thread Tension
Loosen
Tighten
Tension Block
Hand Wheel
Position needle using hand
●
wheel.
Always turn hand wheel towards
✽
you.
CAUTION
Be sure to keep the area under
and around the needle clear.
Stitch Length Regulator
Adjust desired stitch length
●
using stitch regulator dial.
Reverse Stitch Lever
Sewing in reverse is possible
●
when the reverse stitch lever is
in the lowered position.
Make sure to continuously press
✽
the lever to its lowest position
when reverse sewing is desired.
When the feed adjustment dial is
✽
set between 5-7 mm, the reverse
stitch length is always 5 mm.
Hand Wheel
Stitch Length
Reference Mark
1
Lower number
= shorter stitches
Higher number
= longer stitches
Stitch Length Regulator
Reverse Stitch
Lever
7