S&P HORIZON TL-31 Notice D'utilisation page 5

appliance with double insulation,
it does not need to be earthed.
3. Turn the thermostat control to
the maximum position.
4. Select the desired power
(1000W - 2000W).
5. When the room has reached
the desired temperature, turn
the thermostat control slowly
anticlockwise
appliance switches off, with a
gentle "click". From now on,
the heater will switch on and
off automatically, maintaining
the room at a constant tempe-
rature.
6. To switch the appliance off, set
the power selector control to
the O position.
Maintenance
1. Disconnect the appliance from
the mains electrical supply befo-
re carrying out any maintenance
work.
2. After any prolonged period of
non operation, we would advi-
se to clean away the dust that
has accumulated inside by
applying ideally using jet of
compressed air through the air
inlet and outlet grid. This clea-
ning operation should be
carried out by a suitably quali-
fied technician.
3. We would always recommend
to regularly clean the air inlet
and outlet grids.
until the
5
4. Do not immerse the appliance in
water or hold it under the tap.
5. Do not dismantle or interfere
with the appliance, to do so
would invalidate the guarantee.
6. If you detect any anomaly, con-
tact the extensive S&P Official
Service Network.
Note: It is very important to clean
the appliance thoroughly at least
once a year. In this way possible
risks of accident are reduced.
Disconnection due to overheating
In the instance that the unit over-
heats, the thermal overload pro-
tection system operates which
then automatically disconnects
the electrical parts on the applian-
ce from the mains electrical
supply. In such an event, proceed
as follows:
Disconnect the appliance from the
power supply; let it cool down for
15 minutes, clean the inlet and
outlet grid (ideally with a vacuum
cleaner). If the appliance still fails
to work normally after these steps
have been taken, please contact
the S&P Official Service Network.
IP21 230V ~ 50Hz 2000W