S&P HORIZON TL-31 Notice D'utilisation page 4

GB
Instructions for use
Read these instructions carefully
before using the appliance.
The TL-31 vertical standing heater
complies with European standards
EN-60335-2-30. Before operation
we advise to check the condition
of the appliance as any manufac-
turing fault is covered by the S&P
guarantee.
IMPORTANT INSTRUCTIONS
SAFETY WARNINGS
- The heater must not be located
immediately under an electri-
cal socket.
- Do not cover the heater with
objects that prevent the air cir-
culating freely. Obstructing the
airflow increases the risk of
overheating.
- While the heater is in opera-
tion, the cable should not be
right in front of the air outlet.
- Inflammable objects (curtains,
etc.) should not be situated wit-
hin 50 cm of the circle of hot air.
- Always ensure that the air inlet
and outlet grilles are clean.
Before cleaning the appliance
ensure that the unit is discon-
nected from the mains electri-
cal supply.
- Do not handle the appliance
with wet hands.
- If the power supply cable is
damaged, then it must be
replaced in one of our authori-
sed repair workshops and by
authorised personnel in order
not to invalidate the guarantee.
- Do not use this appliance within
the spray zone of a bath, a sho-
wer or a swimming pool.
Power selector control
0 Disconnection
1000W Warm air
2000W Hot air
Thermostat control
The purpose of the adjustable ther-
mostat is to automatically switch the
unit ON and OFF at a selected tem-
perature to maintain a continuous
desired temperature in the surroun-
ding environment. The intermediate
positions of the thermostat control
apply to different temperature levels.
If the room temperature is high, the
thermostat will usually disconnect
the appliance.
Operation
1. Before switching the unit ON,
first check that the electrical
supply voltage coincides with
the voltage indicated on the
product name plate.
2. Extract the cable that is located
inside the appliance and plug it
into the socket. As this is an
4