Glossary; Features - RIDGID R350PNE Manuel D'utilisation

GLOSSARY OF TERMS
Activate (operating controls)
To move an operating control so that it is in a position that
allows the tool to be actuated or that satisfies one require-
ment for the tool to be actuated.
Actuate (tool)
To cause movement of the tool component(s) intended to
drive a fastener.
Actuation system
The use of a trigger, workpiece contact and/or other operat-
ing control, separately or in some combination or sequence,
to actuate the tool.
Air inlet port
In an air tool, the opening to which the compressed air supply
is connected, usually by means of a threaded fitting.
Fastener
A staple, pin, brad, nail, or other fastening device which is
designed and manufactured for use in the tools within the
scope of this standard.

FEATURES

PRODUCT SPECIFICATIONS
Operating Pressure............................................. 50-120 psi
Air Inlet .............................................................. 1/4 in. NPT
Fastener Range .....................Common Bulk Nails 4d - 16d
KNOW YOUR PALM NAILER
See Figure 1, page 14.
The safe use of this product requires an understanding of
the information on the tool and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
HAND STRAP
The hand strap is attachable from the left or the right with
the convenient latches on the top of the palm nailer and is
adjustable for hand size.
DRIVE DEPTH ADJUSTMENT
The tool-free drive depth adjustment lets the operator select
precise driving depth of the fastener.
Jam
An obstruction in the feed or drive areas of the tool.
Maximum air pressure
The maximum allowable pressure of the compressed air, as
specified by the manufacturer, for operating a tool.
Operating control
A control that separately, or as part of an actuation system,
can cause the actuation of a tool.
Trigger
A tool operating control activated by a tool operator's fin-
gers.
Workpiece
The intended object into which a fastener is to be driven
by a tool.
Workpiece contact
An operating control element or assembly on the tool in-
tended to be activated by the material to be fastened.
Air Consumption...........................0.105 ft
Fastener Length ....................................... 1 1/2 in.-3 1/2 in.
Weight ......................................................................2.8 lbs.
MAGNETIC NAIL GUIDE
The magnetic nail guide holds nails securely in place while
driving nails into the workpiece.
QUICK-CONNECT SWIVEL CONNECTOR
The quick-connect swivel connector helps prevent hose
tangles.
SELF-CLEANING AIR FILTER
The self-cleaning air filter keeps debris out of the tool and
extends the life of the tool.
7 – English
/cycle at 100 psi
3