Dimensions - Siemens SEH62.1 Instructions D'installation

Initialization
12HR
_
+
+ 5 sec
SEL
TIME 24HR
+
SEL
CT DN 99:59
_
SEL
EXIT
SEL
Normal operation
Programming the time switch
With the SEH62.1 time switch, up to 8 ON / OFF switching cycles can
be programmed. Each of them can be assigned to an individual day or
block of days.
Press the +/- buttons to switch from normal operation to programming
mode. With the + button, a start is made with program (Prg) 1; with the
– button, a start is made with program (Prg) 8. The currently selected
parameters flash to indicate the programming mode.
Step
Press the + button in normal operation, then
1
press the SEL button
Press the +/- buttons to select the required
weekday or block of weekday or block of week-
2
days, then press the SEL button
Set the required switch-on time with the +/- but-
3
tons, then press the SEL button
Set the required switch-off time with the +/- but-
tons and press the SEL button again so that the
time switch will return to normal operation. The
4
first switching cycle is thus programmed and
memory location Prg 1 is assigned
For programming additional switching cycles on the memory locations
Prg 2...8, press the + button several times until the required memory
location flashes. Then, repeat steps no. 1 through 4.
Summer- / wintertime changeover
Step
Press the - button in normal operation so that DS
1
appears on the display
2 Press the SEL button
Press the +/- buttons to set the time shift of + or –1
3
hour
Press the SEL button to confirm the setting after
4
which the time switch returns to normal operation
4/12 05.05.2003
00:01
_
+ + +
SEL SEL
00:00
_
SEL
23:59
00:00
+
_
99:58
5243F01en
Action
Action
MO
IN / OUT
+
Su
_
Pgr 1 ON
SA
Pgr 1 OFF
Pgr 2 ON
Pgr 8 ON
DS
_
OUT / IN
Changeover of operating mode
Press the SEL button in normal operation. Depending on the current
state, the time switch will switch to ON MANUAL, OFF MANUAL or
AUTO. By repeatedly pressing the SEL button, the time switch will
change the operating mode in the following sequence:
OFF AUTO
Display
Prg 1
ON MANUAL → Output continuously active
Su...Sa
OFF MANUAL → Output continuously inactive
AUTO
E.g.
In MANUAL mode, the programmed switching sequences will be over-
06:00
ridden.
E.g.

Dimensions

19:00
Display
DS
DS----
DS+I
DS-I
G5243X1
Su
+
Mo
Tu
We
Th
Fr
00:00
Sa
+
Su...Sa
SEL SEL
ON -- -- :
Mo...Fr
_
Sa, Su
23:59
Mo...Sa
Mo..We..Fr
_
Tu..Th..Sa
+1
SEL SEL
DS --
-1
SEL SEL
ON MANUAL
SEL
→ Output according to programming
78.8
60
Siemens Building Technologies / HVAC Products
00:00
+
SEL SEL
OFF -- -- :
OUT
_
23:59
OUT
5243F02
OFF MANUAL
56
48
30
5243M01