Control Panel Recognition Programming - hager S761-22 Guide D'installation

Programming
Control panel recognition
programming
During recognition programming, the product
to be programmed for use with the control
panel does not need to be placed next to it. In fact,
we recommend you place the product at a short
distance from the control panel (at least 2 meters
away).
The control panel must be in installation mode for pro-
gramming (see control panel installation manual).
Control panel recognition programming is only
required for the Remote Control application.
To programme the remote-controlled socket to be
operated by a different remote control device, the
original control panel programming must be deleted
as described in the chapter on "Return to factory
configuration".
Perform programming as follows:
Press the
remote-controlled
socket on the Light page
programming
key (for less remote-controlled
than 2 sec.).
The programming
LED will light
up temporarily.
If you make a programming error, the programming
LED will flash quickly. You must carry out the program-
ming sequence again from the start.
97
Press and hold The
the key remote-controlled
socket confirms
until the programming
by its
socket programming
LED lighting
programming
LED lights up. up for 2 sec.
G
B