hager S761-22 Guide D'installation page 100

Configuration
• Example of configuring the remote-controlled socket in Timer mode:
To change the remote-controlled socket configuration to Timer mode for a 15-minute duration, proceed as follows:
1) Start
• Example of configuring the remote-controlled socket in Remote Control mode:
To change the remote-controlled socket configuration to Remote Control mode with activation of Light 1, proceed as follows:
G
B
1) Start
If you make a programming error, the programming LED will flash quickly.You must carry out the programming sequence again
from the start.
2
2) Press twice 3) Press once
to select the Timer to accept
application selection
1
2) Press once to select 3) Press once
the Remote Control
application
5
4) Press the key
5 times to select
the 15 min. period
2
4) Press twice
to accept to select the Light 1
selection application
100
5) End
5) End