Maintenance; Scheduled Maintenance Table - Nilfisk SR 1000S B Instructions D'utilisation

MAINTENANCE

The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
The following table provides the scheduled maintenance. The intervals shown may vary according to particular working
conditions, which are to be defined by the person in charge of the maintenance.
WARNING!
To carry out maintenance procedures, switch off the machine (remove the key from the ignition switch) and,
if necessary, disconnect the batteries.
Moreover, carefully read the instructions in the Safety paragraph.
All scheduled or extraordinary maintenance procedures must be performed by qualified personnel, or by an authorised Service
Center.
This Manual describes only the easiest and most common maintenance procedures.
NOTE
For other maintenance procedures contained in the Scheduled Maintenance Table, refer to the Service
Manual that can be consulted at any Service Center.

SCHEDULED MAINTENANCE TABLE

Procedure
Battery fluid level check
Side and main broom height check and
adjustment
Dust filter cleaning and integrity check
Skirt height and operation check
Filter shaker operation check
Hood safety switch operation check
Main broom drive belt visual inspection
Nut and screw tightening check
Service and parking brake check and
adjustment
Main broom drive belt replacement
Main motor and drive system motor carbon
brush check and replacement
(*): For the relevant procedure, see the Service Manual.
(1): And after the first 8 running-in hours.
146 1957 000(4)03-2016
Every 10
On delivery
hours
USER MANUAL
Every 50 Every 100
hours hours
(*)
(*)
(*)
(*) (1)
(*)
Every 200 Every 400
hours hours
(*)
(*)
11