Charging The Battery - ZTE BLADE S6 Guide Rapide

Card Slot 1
NOTES:
• Place your LTE, WCDMA or GSM nano-SIM card on
the Card Slot 1.
• Place your GSM nano-SIM card on the Card Slot 2.
Installing the microSDHC™ Card (Not
Included)
A microSDHC card can be installed or removed while the
phone is turned on. You need to unmount the microSDHC
card before removing it.
1. Insert the tip of the tray eject tool into the hole on the
microSDHC card tray.
2. Pull out the tray and place the card on the tray, as
shown. Then carefully install the tray back.
NOTE:
Some applications may require a microSDHC card to
work normally or may store certain data on it. Therefore,
it is recommended that you keep a microSDHC card
installed and not remove or replace it randomly.

Charging the Battery

Your phone's battery should have enough power for the
phone to turn on, find a signal, and make a few calls. You
should fully charge the battery as soon as possible.
WARNING!
Use only ZTE-approved chargers and cables. The use
of unapproved accessories could damage your phone or
Card Slot 2
7