Charging The Battery - ZTE BLADE A452 Guide De Démarrage Rapide

NOTE:
Some applications may require a microSDHC card to
work normally or may store certain data on it. Therefore,
it is recommended that you keep a microSDHC card
installed and not remove or replace it randomly.

Charging the Battery

Your phone's battery should have enough power for the
phone to turn on, find a signal, and make a few calls. You
should fully charge the battery as soon as possible.
WARNING!
Use only ZTE-approved chargers and cables. The use
of unapproved accessories could damage your phone or
cause the battery to explode.
CAUTION:
Do not remove or change the built-in rechargeable
battery in your phone by yourself. The battery can only be
changed by ZTE or ZTE authorised service provider.
1. Connect the adapter to the charging jack. Ensure that
the adapter is inserted in the correct direction. Do not
force the connector into the charging jack.
2. Connect the charger to a standard AC power outlet.
3. Disconnect the charger when the battery is fully
charged.
NOTE:
If the battery is extremely low, you may be unable to
power on the phone even when it is being charged. In this
case, try again after charging the phone for at least 20
minutes. Contact the customer service if you still cannot
power on the phone after prolonged charging.
7