Cutting, Sawing And Scraping - Makita TM3000C Manuel D'instruction

2
1
3
012851
Put an application tool (optional accessory) on the tool
flange so that the protrusions of the tool flange fit in the
holes in the application tool and secure the application
tool by tightening the bolt firmly with the hex wrench.
When using sanding application tool, mount the
application tool on the sanding pad so that it matches the
sanding pad direction.
The sanding pad has a hook and loop type fitting system
which allows easy and rapid fitting of a sanding paper.
As sanding papers have holes for dust extraction, mount
a sanding paper so that the holes in a sanding paper
match those in the sanding pad.
To remove a sanding paper, raise its end and peel it off.
Loosen and remove the application tool installation bolt
using a hex wrench and then take off the application tool.
1
2
3
4
012850
When using application tools with a different type of
installation section, use a correct adapter (optional
accessory).
OPERATION
WARNING:
Before starting the tool and during operation, keep
•
your hand and face away from the application tool.
CAUTION:
Do not apply excessive load to the tool which may
•
cause a motor lock and stop the tool.

Cutting, sawing and scraping

CAUTION:
Do not move on the tool forcibly in the direction (eg.
•
towards either side) of tool application with no
cutting edge. It may damage the tool.
1. Application tool
installation bolt
2. Hex wrench
3. Tighten
1. Application tool
installation bolt
2. Holes in the
application tool
3. Adapter
4. Protrusions of
the tool flange
6
012889
Put the application tool on the workpiece.
And then move the tool forward so that the application
tool movement does not slow down.
NOTE:
Forcing or excessive pressure on the tool may
•
reduce efficiency.
Before cutting operation, it is recommended to
•
preset the orbital stroke rate 3 - 5.
Sanding
CAUTION:
Do not reuse a sanding paper used for sanding
•
metal to sand wood.
Do not use a worn sanding paper or sanding paper
•
without grit.
012853
Apply a sanding paper on the workpiece.
NOTE:
Using a test
•
recommendable to determine a correct orbital
stroke rate suitable for your work.
Use a sanding paper with the same grit until
•
sanding the whole workpiece is completed.
Replacing a sanding paper with different grit
sanding paper may not get a fine finish.
material sample to try is