Deltec MCE 600 Instructions D'emploi page 5

Optional Media Box with sliding lid
This item is available as an optional extra to allow use of the multi compact with a greater volume of
media. Larger media such as Siporax or carbon can be added directly to the box, which has a perforated
base and a perforated sliding lid. Finer media such as RowaPhos can be used by the addition of sponge top
and bottom to prevent the media from washing out or by use of a mesh bag.
Use with ozone
skimmers are suitable for use with ozone and will automatically suck the gas through the venturi
hose. A maximum volume of 25 mg/h should be used on tank volumes that are suitable for this skimmer.
Do not use excessive ozone, as it is dangerous and can cause severe headaches.
Maintenance
The skimmer range should require very little adjustment and maintenance due to the high levels
of calcium in marine aquariums and large volumes of air drawn in, it is common for deposits to
accumulate. Regular introduction of a small amount of RO water into the inlet tap whilst running may
help to prevent any build up of salt and debris in the venturi.
The MCE 600 is fitted with an aquabee pump, aquabee pumps are fitted with a little flap inside the outlet
of the pump, which flips from one side to the other depending on the direction of rotation thus ensuring
that the pump always operates at full duty. This is illustrated on the attached drawing. It is recommended
every 3 months to strip down the pump to check and clean the impellor of debris. Ensure that the direction
flap moves easily and if necessary soak the neck of the pump housing in white vinegar or kettle scale
remover.
technical data dimensions power air flow appr. min. height for aquarium size aquarium size
(l/w/h) appr. consumption sump Installation normal stocking light stocking
MCE 600 260x85x500mm 17 Watt 300 ltr./h 575mm 400 ltr. 500 ltr.
Maintenance
The Deltec skimmer range should need very little adjustment and maintenance once set correctly however
due to the high levels of calcium in marine aquariums it is common for deposits to build up on moving
parts requiring periodical cleaning. The MCE 600 is fitted with a Aqua Bee pump. Aqua Bee pumps are
fitted with a little flap (8b) inside the outlet of the pump, which flips from one side to the other depending
on the direction of rotation thus ensuring that the pump always operates at full duty. It is recommended
every 3 months, or when required, that the pumps are removed from the skimmer having first drained the
body of Water.
Check and clean the impellor of debris. Ensure that the direction flap moves easily and if necessary soak
the neck of the pump housing in white vinegar or lime scale remover to dissolve any calcium carbonate
deposits. Make sure that the impeller rotates freely on the ceramic shaft. If not submerge in lime scale
remover.
A build up of calcium, dust and salt can restrict or block the venturi inlet on the connecting pipe work and
reduce the skimming efficiency. This should be checked and carefully cleaned with a toothpick or fine
drill rotated between the fingertips.
It is advisable to stop the pump for approximately 15 minutes once every week in order to dissolve any
dust or salt crystals that may have collected in the venture tube.