Salvis Master Mode D'emploi page 20

en
2. Start-Up
. Prior to its initial start-up, clean the device with a fat-dissolving detergent.
D For cleaning, refer to page 22, chapter 4.
2.1 Establishing operational readiness
Sliding grill
Burner cover
Gas tap
2.2 Lighting the pilot light
Gas lighter
Gas governor for
front burner
20 / 68
. Verify the burner covers' and pilot burner
appropriate caution when placing the sliding
grate!
. Attach the sliding grill.
. Open the gas tap.
Pilot burner
cover
Do not switch on the appliances if you smell
gas in the installation room! Risk of explosion!
Immediately close the gas shut-off device at the
customer location! Do not switch electrical ap­
pliances On or Off! Open windows and doors!
Thoroughly air out the installation room by pro­
viding a draught! Leave the room! Notify the
emergency service of the gas grid operator!
Determine the location of the gas leak after ad­
equate air exchange has taken place!
D After longer operating brakes: For example,
. Press in and hold the gas governor and turn
. Light the pilot light by means of the gas
. After the pilot light's lighting, keep the gas
Pilot light - be­
neath the pilot
burner cover
covers' correct position.
CAUTION! Risk of crushing! Exercise
Open
DANGER! Risk of explosion
if the service valve was closed, the pilot
light's lighting may take a little longer (as the
gas supply line has to draw gas first).
it to the lighting symbol
lighter.
governor pressed for approx. 5 - 10 seconds
− to assure a sufficient heating of the
thermal element
− and to prevent an automatic disconnec­
tion of the gas supply (automatic safety
pilot).
Close