Installation Of The Product - Husqvarna EPOS Reference station Manuel D'utilisation

• Install the reference station where the radio signal
reaches all parts of the work area. Large objects
can block the radio signals.
• It is recommended to have free line of sight
between product and reference station for optimal
performance.
39.3 To examine where to put the
power supply
WARNING:
cable. There is a risk of electrical shock.
CAUTION:
Make sure that the blades
on the robotic lawn mower do not cut the
power cables.
• Put the power supply in an area with a roof and
protection from the sun and rain.
• Put the power supply in an area with good airflow.
• Use a residual-current device (RCD) when you
connect the power supply to the power outlet.
• Extend the low-voltage cable if necessary. The
low-voltage cable can be extended up to 100 m /
328 ft.

39.4 Installation of the product

Read and understand the instructions about the
reference station. Refer to To examine where to put the
reference station on page 43 .
Read the Operator's manual for the robotic lawn mower
to be used together with the reference station.
You can install the reference station on a post or a wall.
WARNING:
about electrical safety.
WARNING:
used with the power supply unit supplied by
Husqvarna.
WARNING:
supply at a position where there is a risk that
it can become wet. Do not put the power
supply on the ground.
WARNING:
power supply. Condensed water can harm
44 - Installation
Do not cut the low-voltage
Obey national regulations
The product is only to be
Do not put the power
Do not encapsulate the
the power supply and increase the risk of
electrical shock.
WARNING:
Install only to an residual-current device
(RCD) when connecting the power supply to
the wall socket. Applicable to USA/Canada.
If power supply is installed outdoors: Risk of
Electric Shock. Install only to a covered
Class A GFCI receptacle (RCD) that has an
enclosure that is weatherproof with the
attachment plug cap inserted or removed.
WARNING:
and extension cable must be outside the
work area to avoid damage to the cables.
WARNING:
when you install the reference station in a
high position. Make sure that you have a
stable position when you install the
reference station.
WARNING:
objects during the installation of the
reference station. This can result in injury.
CAUTION:
Movements of the reference
station will affect the correction data sent to
the product with the accurate position. The
reference station must be installed tightly on
the post or wall.
CAUTION:
The items on the map will
change position if you move the reference
station. Adjust the items on the map or do
the installation again in the Automower
Connect app.
39.4.1 Installation tools
• Screwdriver, Torx 20.
• Hex key, 4 mm. Included in the carton.
39.4.2 To install the reference station on a
post
1. Attach the post tightly to a wall, roof top or the
ground. Make sure that the post cannot move or
be accidentally moved.
Risk of Electric Shock.
The power supply cable
There is a risk of falling
There is a risk of falling
®
1512 - 001 - 11.11.2020