Husqvarna EPOS Reference station Manuel D'utilisation page 45

2. Attach the support bracket and one of the post
brackets to the arm with the 4 screws (4 mm hex
key).
Note:
The post brackets are available in 2
dimensions to fit different dimensions of the post.
Select the applicable post bracket for your
installation.
3. Put the arm on top of the post.
Note:
The reference station must be installed at
the top of the post.
4. Attach the reference station to the post with the 2
screws (4mm hex key).
1512 - 001 - 11.11.2020
5. Pull the cable on the reference station through the
slot in the arm and install the reference station on
the arm.
6. Attach the connector to the clips on the arm.
7. Tighten the screw (Torx 20) on the arm of the
reference station.
Installation - 45