Assembly; Operation - Ryobi P460 Manuel D'utilisation

UNPACKING
This product requires assembly.
 Carefully remove the tool and any accessories from the
box. All items listed in the Includes section must be
included at the time of purchase.
WARNING:
Items in this Assembly section are not assembled to the
product by the manufacturer and require customer instal-
lation. Use of a product that may have been improperly
assembled could result in serious personal injury.
 If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always remove battery pack from the tool when you are
assembling parts, making adjustments, changing acces-
sories, cleaning, or when not in use. Removing battery
pack will prevent accidental starting that could cause
serious personal injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Hearing protection may also
be required depending on the type of attachment used
and as prescribed elsewhere in this Operator's Manual.
Failure to do so could result in objects being thrown into
your eyes and other possible serious injuries.

ASSEMBLY

WARNING:
Do not attempt to modify this product or create acces-
sories or attachments not recommended for use with this
product. Any such alteration or modification is misuse
and could result in a hazardous condition leading to pos-
sible serious personal injury.
CONNECTING THE PEN HOLDER AND FLEX
SHAFT TO THE ROTARY TOOL CONSOLE
See Figure 1, page 11.
 Slide the flange on the pen holder into the opening on
the side of the rotary tool console until it is fully seated.
NOTE: Once fully seated, the tab on the flange will snap
into the housing, preventing the pen holder from being
removed.
 Place the collar of the flex shaft onto the threaded outlet
on the rotary tool console.
 Turn the collar clockwise and tighten securely.

OPERATION

WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
APPLICATIONS
You may use this product for the purposes listed below:
 Cutting
 Sanding
 Polishing and buffing
 Engraving
 Drilling
KEY HOLE HANGER
To mount the rotary tool console, use the key hole hanging
feature. Screws should be installed so that the center
distance is 5 in.
INSTALLING/REMOVING BATTERY PACK
See Figure 2, page 11.
To install:
 Insert the battery pack.
 Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured in the
product before beginning operation.
7 — English