Attaching Estore - Dometic eStore Instructions De Montage Et De Service

Attaching eStore

7 Attaching eStore
!
WARNING!
Do not secure the eStore using straps, or similar, passing over the plastic
eStore cover. This will result in damage to the unit.
I
NOTE
If you use multiple connected eStores: configure and mark eStore num-
ber on each eStore before installation in the vehicle, see chapter "Con-
necting multiple eStores" on page 19.
Observe the following instructions on installation location
• eStore can be installed vertically (fig. a, page 6) or horizontally (fig. b,
page 7), on a flat and stable surface.
• eStore must not be installed close to combustible materials.
• The installation location should be protected from moisture and dust.
• Leave at least 2 cm of space around eStore and ensure good ventilation. The
installation should avoid low temperatures during winter operation (charging) to
ensure continuous operation.
Avoid low temperatures during winter operation.
• For safety reasons, note the location of existing wiring harnesses, wires and other
components within the installation area, in particular those which are not visible,
when installing the eStore (when drilling or screwing etc.).
• If you install more than one eStore, leave at least 1 cm of space between the
eStores.
➤ Select a suitable location and secure eStore safely.
➤ Vertical mounting: Use the integrated fixing feet to secure the eStore (fig. a,
page 6).
Suitable mounting brackets are available as accessories (see chapter "Accesso-
ries" on page 12).
➤ Horizontal mounting: Secure eStore with two straps or bands across the
device (fig. b, page 7). Pass them between the handles and mounting feet and
fix them to the mounting surface. This will ensure the eStore does not move when
the vehicle is in motion.
Suitable mounting brackets are available as accessories (see chapter "Accesso-
ries" on page 12).
16
eStore
EN