Assembly And Operation - Fagor VCE-406 Manuel D'utilisation

interior 29/6/06
to change the filter, to clean it or when
you have finished using it.
• Do not use your vacuum cleaner
outdoors, nor on wet surfaces, nor pick
up damp or wet dirt.
• Do not pick up inflammable liquids such
as cleaning fluids, petrol, etc., or their
vapours.
• Do not pick up objects which are hard,
sharp or excessively large, nor matches,
hot ashes, cigarette butts and similar.
• Do not allow children or handicapped
persons to use the appliance.
• Do not leave the appliance near to
ovens, heaters or hot radiators.
• Do not move the appliance by pulling the
cord or the suction hose. Use the carry
handle.
• Do not use the vacuum cleaner without
its filters.
• Replace the filters before picking up fine
dust or cleaning new carpets.
• Do not pick up very fine dust such as
cement, very fine sand or flour, etc.
• Do not use the appliance if there is any
obstruction in the airways, as this may
dangerously overheat the motor.

4. ASSEMBLY AND OPERATION

To extend the telescopic wand (13) to the
desired length, push the catch forward then
insert the brush (15), the parquet brush (16)
or one of the nozzles (17), then insert the
suction hose (11) into the other end of the
telescopic wand. (Fig. 2)
Insert the suction hose into the suction hole
(1), bringing the suction hose tip (10) and
the suction hole together until they fit firmly..
To release it, press the button on the suction
hose and pull. (Fig. 3)
Pull the connection cord (24), and connect it
to the mains.
Caution: A yellow mark on the power cord
indicates the ideal length. Do not pull more
cord out when this mark is visible, and
never exceed the red mark as this could
cause irreparable damage to the automatic
cord rewind function.
16:11 Página 9
Push the on/off pedal (7) to operate the
vacuum cleaner. When you wish to stop it,
push the same pedal again. Before
operating the vacuum cleaner, turn the
power down to the minimum, using the
power setting dial (5), and then select the
power you desire.
Using the power setting dial (5), you can
regulate suction power according to type of
flooring, from Minimum (used for curtains
and delicate fabrics) to Maximum (for
intense dirt and hard flooring). Generally
speaking, except in cases of vacuuming
extreme dirt or delicate fabrics, it is
advisable to use the vacuum cleaner in the
intermediate power-saving position between
MAX and MIN.
Suction power may be regulated manually
with the manual air regulator on the handle
(12) (Fig. 4)
Closed window: greater suction power.
Open window: lower suction power.
The parquet brush (11) has two operating
positions according to the type of flooring
(Fig. 5):
a) Hard flooring position
b) Rug and carpeting position.
When finished using the vacuum cleaner,
stop it, disconnect it and step on the
automatic cord rewind pedal (4). Make sure
that the cord winds up straight, helping it
with your hand where necessary.
Storage: To store the appliance, you may
place it in a vertical position, inserting the
hook on the telescopic wand into the
storage area located in the lower part of the
vacuum cleaner (Fig. 6) or hooking the
brush into the storage area of the back part
of the carry handle (Fig. 7)
The nozzles (17) may be kept on the
accessories clip (14) on the telescopic
wand.
10