Makita 4350T Manuel D'instruction page 8

Front flush cuts
1
2
► 1. Base 2. Bolt 3. Hex wrench
Loosen the bolt on the back of the base with the hex
wrench and slide the base all the way back. Then
tighten the bolt to secure the base.
Cutouts
Cutouts can be made with either of two methods A or B.
A) Boring a starting hole:
► 1. Starting hole
For internal cutouts without a lead-in cut from an
edge, pre-drill a starting hole 12 mm (1/2") or more
in diameter. Insert the blade into this hole to start
your cut.
B) Plunge cutting:
3
You need not bore a starting hole or make a
lead-in cut if you carefully do as follows.
(1)
(2)
(3)
(4)
Finishing edges
1
To trim edges or make dimensional adjustments, run the
blade lightly along the cut edges.
Metal cutting
Always use a suitable coolant (cutting oil) when cutting
metal. Failure to do so will cause significant blade wear.
The underside of the workpiece can be greased instead
of using a coolant.
Rip fence set (optional accessory)
CAUTION:
• Always be sure that the tool is switched off
and unplugged before installing or removing
accessories.
8 ENGLISH
Tilt the tool up on the front edge of the base
with the blade point positioned just above the
workpiece surface.
Apply pressure to the tool so that the front
edge of the base will not move when you
switch on the tool and gently lower the back
end of the tool slowly.
As the blade pierces the workpiece, slowly
lower the base of the tool down onto the
workpiece surface.
Complete the cut in the normal manner.