Makita 4350T Manuel D'instruction page 7

Then connect a Makita vacuum cleaner to the dust
nozzle.
1
► 1. Dust nozzle 2. Hose for vacuum cleaner
CAUTION:
• If you try to remove the dust nozzle forcibly, the
hook of the dust nozzle can be diminished and
removed unintentionally during operation.
OPERATION
CAUTION:
• Hold the tool firmly with one hand on the main
handle when performing the tool. If necessary,
the front part of the tool may be supported by
the other hand.
• Always hold the base flush with the workpiece.
Failure to do so may cause blade breakage,
resulting in a serious injury.
1
► 1. Cutting line 2. Base
Turn the tool on without the blade making any contact
and wait until the blade attains full speed. Then rest
the base flat on the workpiece and gently move the tool
forward along the previously marked cutting line.
When cutting curves, advance the tool very slowly.
Bevel cutting
CAUTION:
• Always be sure that the tool is switched off and
unplugged before tilting the base.
With the base tilted, you can make bevel cuts at any
angle between 0° and 45° (left or right).
2
Loosen the bolt on the back of the base with the hex
wrench. Move the base so that the bolt is positioned in
the center of the bevel slot in the base.
1
2
► 1. Base 2. Bolt 3. Hex wrench
Tilt the base until the desired bevel angle is obtained.
The V-notch of the gear housing indicates the bevel
angle by graduations. Then tighten the bolt firmly to
secure the base.
1
2
► 1. Graduation 2. Bevel slot 3. Base 4. Gear housing
5. V-notch 6. Bolt
7 ENGLISH
3
2
3
4
5
6