Functional Description; Depth Adjustment - Makita 6821 Manuel D'instruction

FUNCTIONAL DESCRIPTION

CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function on
the tool.

Depth adjustment

A
1
2
The depth can be adjusted by turning the locking sleeve.
Turn it in "A" direction for less depth and in "B" direction
for more depth. One full turn of the locking sleeve equals
2 mm (3/32") change in depth.
Adjust the locking sleeve so that the tip of the locator is
flush with the base of the screw head. Drive a trial screw
into your material or a piece of duplicate material. If the
depth is still not suitable for the screw, continue adjusting
until you obtain the proper depth setting.
002611
1. Locator
2. Locking sleeve
B
002617
002618
Switch action
1
2
CAUTION:
• Before plugging in the tool, always check to see
that the switch trigger actuates properly and returns
to the "OFF" position when released.
To start the tool, simply pull the switch trigger. Tool speed
is increased by increasing pressure on the switch trigger.
Release the switch trigger to stop.
For continuous operation, pull the switch trigger and then
push in the lock button.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
Reversing switch action
1
This tool has a reversing switch to change the direction of
rotation. Move the reversing switch lever to the
tion (A side) for clockwise rotation or the
side) for counterclockwise rotation.
CAUTION:
• Always check the direction of rotation before opera-
tion.
• Use the reversing switch only after the tool comes
to a complete stop. Changing the direction of rota-
tion before the tool stops may damage the tool.
4
002627
1. Switch trigger
2. Lock button
002634
1. Reversing
A
switch lever
B
posi-
position (B