Saving, Resetting And Restoring Settings; Save Contractor Default Settings; Reset Contractor Default Settings; Restore Contractor Default Settings - Rain Bird WR2 Wireless Sensor Manuel De L'utilisateur

Saving, Resetting and
7
Restoring Settings

Save Contractor Default Settings

Reset Contractor Default Settings

The Contractor default setting stores programming details
related to rainfall and temperature set points.
5 7
Section and .

Restore Contractor Default Settings

restore.
Once the Controller Interface
for five (5) seconds to save
contractor default setting. All
in unison one time to indicate
program is saved.
+ –
Press and
default settings are restored.

Restore Standard Setting

8

Select the Sensor Location

The communication range for the WR2
Wireless Sensor is 700 feet (213.4 meters).
successful pairing. The Sensor updates its signal
placement can improve signal strength.
Signal
GOOD
Install
POOR
DO NOT install
receives as much rain and sunlight as the landscape. Be
WR2 Wireless Sensor
–
Press the
to cancel the Contractor
default setting and restore
the "Standard Setting":
"programmed irrigation"
"Standard Setting" is active.
Sensor LED
1-4 Blinks
Does not blink
7