Scan Time Or Quad Function; Setting Screen; Menu System Setup - Extel WESV 82500 Guide D'installation Et D'utilisation

f. Scan Time or QUAD function (to use only in the case of several cameras)
Audio Vol
Pair CAM
CH1
CH3
When you are in QUAD mode, the key
qt u ) to access again the menu.
mode (press
g. Setting screen

"Menu System Setup" :

Press the key of the monitor or the remote control unit, a menu appears:
Audio Vol
Scan Time
Pair CAM
10
Scan Time QUAD
CAM1 ON
CAM2 ON
CAM3 ON
CAM4 ON
1 2 3 4
Systern Setup
Factory Reset
CH2
CH4
10
OFF
CAM1 ON
CAM2 ON
CAM3 ON
CAM4 ON
1 2 3 4
Systern Setup
Factory Reset
CFI EXTEL WESV 82500 - 06/2009 - V1
Press the button
SCAN TIME with the keys t and u, se-
lect the scrolling time (5, 10, 15, 20 se-
conds) or the display in quad mode.
(Reminder: only the cameras set on
"ON" viewing mode will be visible, see
paragraph d).
The camera 1 in the left upper corner of
the screen
The camera 2 in the right upper corner
of the screen
The camera 3 in the left lower corner of
the screen
The camera 4 in the right lower corner
of the screen
Black screen for the cameras non-con-
nected or not activated (OFF).
is not activated. First, you have to quit the QUAD
With the key q of the monitor or the
remote control unit, go to the menu:
"System Setup" and press
of the monitor on
.
11GB